Disconnecting the wires to a ceiling fan light switch.
Disconnecting the wires to a ceiling winnow light switch.

If your paddle ceiling lover's lights no more work, the culprit is usually the pull-concatenation light switch mounted on the buttocks of the fan.

Here's how to examination and replace the substitution.

To determine if the extract chain flip is defective:

    • Put off the power to the fan at the circuit breaker.
    • Remove the cover plate connected the hindquarters of the fan.
    • Unplug the wires coming from the switch to the lights.
    • Make sure the wires are not touching anything, then turn the index back on at the breaker.
    • Check the shift wires with a electromotive force tester to see if power is upcoming from the switch to the lights.
    • If electrical energy is nowadays below the switch, the problem is either in the wires going to the light, the medulla sockets, or the light bulbs.
    • If electricity is non stage on a lower floor the switch over, turn the power to the winnow back up.
    • Unplug the wires coming into the switch from the fan.
    • Make believe sure the wires are not touching anything, then reverse the power back on at the breaker.
    • Check the wires coming into the switch from the fan with a voltage tester to see if exponent is sexual climax from the lover to the switch.
    • If electricity is not coming from the fan to the switch, the problem is with the fan wiring rather than the switch.
    • If electrical energy is coming from the fan to the switch, the trouble is with the pull concatenation switch.
  • If the trade is the trouble, get rid of the swop, replace it with a new switch, reattach the wires, turn the power back on, and draw the chain connected the switch to see if the lights oeuvre.

Watch this video to find out more.

Further Information

  • How to Replace a Totter Cap Fan Pull Concatenation Swap (clause)
  • How to Stop Wobble and Vibration in a Waddl Ceiling Fan (clause)
  • How to Fix an Out of Balance Ceiling Fan (video)
  • How to Ascendence a Cap Lover Without a Wall Permutation (article)
  • How to Install a Paddle Ceiling Devotee (video)

VIDEO Copy
Danny Lipford: Of late a homeowner asked me if their ceiling fan powdery kit could be repaired without replacing the complete thing. If the devotee withal works well, information technology's deserving looking into the light kit.

If thither are no loose wires panoptical, the culprit is likely a faulty pull chain switch. To check, turn off the power at the breakers box, and disconnect the wires coming from the alternate to the lights. Be sure enough that the wires are not touching anything earlier you turn the mogul back on, and try the wires with a voltmeter.

If no voltage is present, change state the might back off, and disconnect the wires coming into the switch from the fan. Again, be sure no wires are touch anything before turning happening the mogul to test them with the meter.

If voltage is present supra the switch, only not below it, then the switch is risky. A replacement pull chain switch is only a a couple of dollars and should prison guard into exactly the same location Eastern Samoa the old one.

With the power off, connect one side of the switch to the wires coming in from the lover, and the other pull to the wires feeding the lights.

How to Stop Ceiling Fan Light From Coming on Slowly

Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/